M109 Rider Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
I can't think for the life of me where to hide the wire. I am daring to pull the driveshaft cover and drill a hole and feed it through and secure it through several holes alond the way...anyone?
 
G

·
Until a shaft cover comes out that I can run the wires behind, I just wrapped them in black electrical tape and ran it down the shaft and used tie wraps to secure it.
 

·
Registered
Joined
·
130 Posts
I ran the wires through quarter inch plastic chrome conduit and used the little stick on clamps from wallyworld this looks good and know one has pointed it out or asked what was going on and its looks pretty good ran the conduit from the tag bracket all the way down the drive shaft up and under the seat where we tapped into the brake circut. Hope this helps you out . I will probally change this when a chrome cover comes out for the driveshaft.....
 

·
Registered
Joined
·
69 Posts
You can run a bead of clear caulk/adhesive along the inside of the drive shaft cover
 
1 - 6 of 6 Posts
Top