M109 Rider Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #9 ·
Ok, I have not seen that kit before. I went with the cycle house kit by DLP. It mounts into the top plug on the hub. Easy install and keeps the plate a little closer in. That set up you have uses an expansion plug that goes inside that axle if I am not mistaken. Did the expansion plug not lock in.

Here's what I have
http://www.directlineparts.com/product.asp?pid=6250&str=290
That is exactly what is wrong! The expansion plug is locked in and I can't get it loose. You have any idea how to get it out?:dontknow:
 

·
Registered
Joined
·
29 Posts
Discussion Starter · #10 ·
that is how shane mounts his side plates that is a threaded rod that goes throug the rear axle it should have a pin in the other side exhaust side to hold it from turning and a lock nut!!! pm me if you need more help
It did not have a pin on the other side. It just locked in and I now I cannot get it out!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top