Joined
·
127 Posts
Hey Guys,
Im getting a set of SS cables made up for me from HEL Performance. For the rear brake line they asked for " a measurement length, and degree of bend required on each banjo, and they could make one up for me." I asked how this is done and I had returned " The way I do it is to use a length of solder wire, secure it to the middle of the banjo on one end and run the wire on the prefer and most direct rout to the rear calliper."
I'm still not sure how to do this does anyone know the measurements and degrees of bend for the rear line on the m109r
Im getting a set of SS cables made up for me from HEL Performance. For the rear brake line they asked for " a measurement length, and degree of bend required on each banjo, and they could make one up for me." I asked how this is done and I had returned " The way I do it is to use a length of solder wire, secure it to the middle of the banjo on one end and run the wire on the prefer and most direct rout to the rear calliper."
I'm still not sure how to do this does anyone know the measurements and degrees of bend for the rear line on the m109r