M109 Rider Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
hey guys,im lookin for advice. i just replaced my fuel strainer and figured id check my ecm for codes. i have no codes, but the egv trick doesnt seem to be accurate. should the hash mark gradually rise as i twist the throttle? mine only jumps from bottom to top.:dontknow:
 

·
Radio Active Member
2007 Candy Sonoma Red
Joined
·
22,865 Posts
It should gradually rise as you turn the throttle. What it is showing you is the reading from the throttle position sensor.

I'm not sure why it would just jump. Is the bike running OK?
 

·
Registered
Joined
·
29 Posts
Discussion Starter · #4 ·
sorry for the delay. the throttle response doesnt feel "right", but it isnt showing a f1 light nor any codes. i just changed the fuel strainer because i did get a f1 light twice while riding, though it did go away quickly. the only difference in its behavior is its idling at 900 instead of the usual 1100rpms and my throttle response feels like stock, before the jsd tre.
 
1 - 4 of 4 Posts
Top