M109 Rider Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
208 Posts
Discussion Starter · #1 ·
Can anyone tell me were to get the information how to fit the scorpion tips to my M109r i was given a link by a member but Raw Design have taken it down does anyone know why they have done this ? also i emailed Raw and asked them to send me instructions and to date i have received nothing.
 

·
Registered
Joined
·
4,890 Posts
Can anyone tell me were to get the information how to fit the scorpion tips to my M109r i was given a link by a member but Raw Design have taken it down does anyone know why they have done this ? also i emailed Raw and asked them to send me instructions and to date i have received nothing.
i have them. PM me or post up your email address and i will send it to you.
 

·
Registered
Joined
·
208 Posts
Discussion Starter · #6 ·
Many Thanks !! now i will just wait for the delievery of my pipes they told me about a week !!! is there anything i need to be careful with these instructions or are they accurate.Thanks for your help guys.
 

·
Registered
Joined
·
4,890 Posts
you should be ok. i believe the 2008 models and newer had welded a piece on the heat shields that needed to be cut with a dremel. the older models did not require this.
 
1 - 9 of 9 Posts
Top