M109 Rider Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
137 Posts
Discussion Starter · #1 ·
In the process of finishing my plate bracket.
Axle bolt left and spike nut left .
Lights will be on the plate or shine down from under the fender on to the plate.


 

·
Registered
Joined
·
6 Posts
That's the cleanest plate holder I've seen so far. Will the pegs scrap before the plate holder. How much would you charge for one? (Including all necessary parts?)
 

·
Registered
Joined
·
137 Posts
Discussion Starter · #4 ·
It will be rotated up more then what is in the pic. The bend has a 1 1/2 inch bigger radius than the hub. It is
.125 aluminum 2 pieces tigged together then hand filed and shaped. Like all stuff hand made no 2 are a like or
perfect. For that reason I probably wont sell them less hassle.
 

·
Registered
Joined
·
64 Posts
Good looking plate holder. :bigthumbsup: I like the the way you offset it to the inside. Allot of the plate holders out there look like a birth defect or something you would always be running your leg into.

What radius did you use if you don't mind me asking?
 

·
Registered
Joined
·
1,552 Posts
Axle bolt left and spike nut left .
did ya forget the pic of these? i'm real interested in seeing how you did it. it looks great.
 

·
Registered
Joined
·
147 Posts
:bigthumbsup:

Very kewl!
I need something like that for my 9! It would be a great start on cleaning up the rear of the bike. :beer3:
 

·
Registered
Joined
·
702 Posts
This holder is so good.

KW, if you ever decide to make just a couple more, I (and lots of others on this site) pay cash.


Pleeese? :joke:
 
1 - 11 of 11 Posts
Top