M109 Rider Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
401 Posts
Discussion Starter · #1 ·
Hey Guys I have a question. I removed my stock exhaust and in doing that you have to disconnect the EXCVA lead wire couplers. These are the two plugs that plug into and control the cable slots of the EXCVA pulley. Once I removed the stock exhaust and mount on my new exhaust V&H Big Shots. There is nothing for this to plug into on my new pipes. And now my FI light is on. After reading HINK's FAQ's I see that to disable the FI light I need to unplug the computer wire harness and disconnect pin #7. Is the right? That I just leave the two EXCVA wire couplers unplugged and disconnect the computer wire harness and disconnect pin #7? Please help or PM me. I want to make sure I installed them right before I disconnect pin #7 to turn of the FI light.
 

·
Registered
Joined
·
401 Posts
Discussion Starter · #3 ·
Thanks and I can leave the front and rear HO2 sensor lead wire couplers plugged up right?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top