M109 Rider Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
130 Posts
Discussion Starter · #3 ·
Stock risers are the point from which the altered measurements are made, i.e., they are the "0" point. Are you looking for measurements in relation to something else????
What to put new bars on (and will be geting bars with the rises made as part of the bar) would like to rase the bars up a little and don't want to come back at all. I can find measurments on the stock bars but not on the risers.
 

·
Registered
Joined
·
2,185 Posts
you should be able to just measure yours to get this useing a tri square and a tape measure I`d say they are up 8" to the center of the hole for the bars and pulled back around 2 1/4" to the center of the handle bar hole!! these are just rough measurements
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top