M109 Rider Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
189 Posts
Discussion Starter · #1 ·
Yesterday I installed the JSD 3m on my 109.I am not sure if I gained much performance.I went for a short ride and I think it might be a little faster.It did seem to come off the rev limiter and back to power better.I hope the ground is working.How can I be sure if its grounded proper?
 

·
Registered
Joined
·
55 Posts
Easy and cheesy way to test for ground...Go to Radioshack and get a $15-20 mini-Multimeter. Use the diode tester (the one that beeps usually). Touch one end to chasis of bike and the other lead to JSD component. If you get a beep it's grounded. I think that hardware stores sell little light up LED w/ prongs that test out grounds on wall sockets for like $5 but the leads are usually too short to do much with.
 
1 - 4 of 4 Posts
Top