M109 Rider Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,367 Posts
On mine there appeared to be no welds but couldn't get them to budge. I assumed it was pressed in and figuered it was not worth the effort to drill out that much steel. Good luck and let me know how you did it. I would love to have hidden grip heaters
 

·
Registered
Joined
·
3,367 Posts
Aha! maybe I didn't look underneath the bar. I drilled and tapped the weight, screwed a bolt in and tried a sliding hammer hoping they were glued in. Maybe I'll look for the spot weld to drill out and try the sliding hammer again.
I'm a little concerned about loosing the anti-vibration weights, there may be a trade off: added vibration for hidden wires.
And the bars will have to come off to drill the holes for the wires.
There's a good spot to put a hi/lo/off toggle switch hidden under the tach, easily reachable when riding.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top