M109 Rider Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,185 Posts
question: can u remove the hubs&fit the 300 too a

dlp swinging arm!without removing the shaft!
no you can not the easest way to do this is after you install the new swing arm get the 300 in the swing arm the pull off your secondary drive houseing off put the hub back on get the 300 up into place and the axle back in and get that part all done then you can simpoly slid the u joint on to the shaft and then reinstall the secondary houseing back on and your done the secondary houseing is held on by 4 bolts and it aso holds your speed sensor!! this sounds ALOT more difacolt then it actualy is but it is the best way to do this by along ways Good luck Bro you will LOVE how that 300 looks when your done!!!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top