M109 Rider Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
hey guys i got a problem???. Im intalling a 280 tire on a 10" rim:drool:.
and everything was going good until i had to put the drive shaft back together. so i went back to the trusty m109rider forum for info and found
lomounts install sugestion so i tried it and it seemed to be easier than trying to stab the drive shaft into the u joint blind. but i now i cant get the u joint to connect to the transmision. anybody know the secret on how to get this together im at a lose right now. i apreiciate any ideas thanks
 

·
Registered
Joined
·
47 Posts
Discussion Starter · #3 ·
Yeah thats what i did,how do you get the u joint to fit back in its place with the rubber gromit in the way?
 

·
Radio Active Member
Joined
·
27,666 Posts
Loosen up the swing arm. That will give you a little more wiggle room. Take the rectifier off also as the swing arm needs the room to drop and it is in the way.
 

·
Registered
Joined
·
47 Posts
Discussion Starter · #8 ·
Thanks for the offer Josh, but I did what you said and kept trying till i
got it,and your right what a PITA. I apprieciate the thanks, Now all I got
to do now is figure out how to post these bad ace 9 pics :dontknow:. lol
 
1 - 8 of 8 Posts
Top