M109 Rider Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-14 of 15 Results
  1. New Member Introductions
    Calling all M109ers, calling all M109ers. I am looking for assistance in a related problem with the FI light. I have a 2014, with 4,9524 miles, stock pipes (drill out). All attempts to check the codes, have failed. Before anyone ask the question, I held the connector with the tab on top...
  2. M109R Shop Talk
    Hello 9ers. I got a 2015 M109R with hard krome dual radius exhausts, Power Commander V, KN filters. It's been 3 moths since I got the bike and I've been riding it with no problems until last week. FI light came on and I used the special tool and got the -C46 code. I removed the servo motor since...
  3. M109R Shop Talk
    I realize this has been hashed out a couple of times now. But all threads contain links to unavailable photos of the jumper and such. I have let my 2012 M109R sit for much longer than I have in the past. (Months). Went to the shed to run the bike and the 8yr old battery was done. Got new...
  4. General MC Board
    I just finished putting my bike back together after painting, ran fine before I took it apart. Now it will not start, turns over but nothing, F1 light is on chec comes up in the speedo, fuel light is blinking? could I have done something to fuel pump when I took it out? Anysugggestions?
  5. M109R Shop Talk
    I'll start with saying I've searched and read the topics on here about an FI light and no code (C00), which cover the following with my responses: Resetting the ECU by pulling the battery terminal for 20 minutes - The FI light comes back. Possible SET valve elimination - I haven't done this...
  6. General MC Board
    How do I delete the error code. please , it won't start.
  7. M109R Shop Talk
    Hi All, I haven't been here for a long while and I've long since sold my very cool 2007 SE (Blue and White!). I've had a Vulcan 1700, then a Raider and currently a 2013 Vaquero (lowered, 21" front wheel, mini apes with internal wiring, Vance and Hines 2 into 1, PC 5, Big Air) and like you...
  8. C109Riders
    Hello all---This past August I rode from Sacramento, CA to Sturgis. Bike ran great. Traveled along Interstate 80 at 90 MPH as if I was in my living room. Took 2 1/2 days to get to Sturgis. After 1 day in Sturgis we were riding by Crazy Horse and I had a light come on by the F1 on my dash. Took...
  9. M90-Riders
    I have a 09 M90 with cobra swept, FI200R and O2 bypass. I have had the rectifier replaced the week I bought it. I haven't had any problems out of the bike since then. The other day while riding the bike started spitting and sputtering along with backfiring. Same thing it did when the factory...
  10. General MC Board
    I had a question that may be different from the servo set valve issue many seem to have had, then again maybe not. So here's the scoop to see if someone can shed some light. I, like many, removed the gas tank sticker the instant I purchased the bike about 2k miles ago. I ran on 87 octane...
  11. M109R Shop Talk
    Help!! My M109 Actuator Assy, Exhaust control has gotten where it works only sporadically. (if I take a hammer and hit it, I can get it to start up again.) When it stops my F1 light start to show up. I was hoping that perhaps someone here on this site has had a similar problem and found a...
  12. M109R Shop Talk
    Installed the PowerPro on my '06 9er this Wed. Fired it up that night, idled well, sounded good, no problems, no FI light. Rode to work the next day and it ran great there and back home, I was a happy camper.:doorag: And then....last night as I'm heading to Irnjoy's house for help installing my...
  13. M109R Shop Talk
    Well, still have the FI light and flashing FI in odometer after disconnecting the battery overnight. From the "Special tool: thread: C28: Secondary throttle valve actuator (STVA) C29: Secondary throttle position sensor (STPS) - (Note *2) *2: When the secondary throttle valve actuator and...
  14. M109R Shop Talk
    Ok, Suzuki talks about a "special tool" to reveal the FI codes in the manual. The "special tool" is $15.99 from Suzuki. In reality it is a single toggle switch with two wire leads and probably a pin insert at each end. The "special tool" works by using the two leads to connect two jumpers on a...
1-14 of 15 Results
Top