Search Results for ‘brakes’

Hey Brothers, Barakes are worn the @#*% out!!!! Whats best to use, Kevlar, sintered, semi-sintered, brand name?:doorag:

I'm a little over 13K miles and my pads don't seem to need replacement... is this normal? I'd hate to find out later that I should have replaced those pads before something bad happens :o

If you have never replaced brake lines or bled brakes, please read this how-to from start to finish before even contemplating this mod. If after reading this how-to, you do not feel comfortable tackling the job yourself, DO NOT TRY! Take your bike and lines to a mechanic. Your brakes are...

Drain the front brake system: Remove the bleeder screw cap from the right caliper (or left if you prefer). Place an 8mm 6-point box-end wrench over the bleeder screw. Place the Mityvac suction tube over the end of the bleeder screw. Pump the Mityvac to build a vacuum and then open the bleeder...

This is Part 3 of a 3-part How-To post: Check clearances: Turn the bars full left and right to ensure adequate clearance at the master cylinder. WARNING! When you turn the bars to the right, do it s-l-o-w-l-y! If you have rotated the bars down from the stock position, the double banjo bolt...