M109 Rider Forums banner

Help with License plate bracket install

556 views 0 replies 1 participant last post by  vinnytheb 
#1 ·
Ok, am I a moron? I installed the Cycle House license plate bracket, the one with the rubber o ring. I thought that you tighten the bolt and it compresses the O ring against the inside of the axle. However, its not working, the bracket is not holding horizontal. Did i miss a part of the installation. Any help would be appreciated. thx Vin
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top