Search Results - M109Riders.com

Search:

Type: Posts; User: 1 BAD 9

Page 1 of 4 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    2
    Views
    240

    I don’t have anything added to the bike that...

    I don’t have anything added to the bike that would draw power while the switch is off, except my LED lights, but they are off? I pulled the battery, checked the voltage, and it’s 13.8! I did find a...
  2. Replies
    2
    Views
    240

    Odessey battery problems

    Bought a new Odessey battery about 6 weeks ago. Fired the bike up and all was fine. Didn’t ride the bike but would start it up every week and let it run to keep battery charged. I missed a few weeks...
  3. Replies
    1
    Views
    246

    Rear cylinder exhaust cool?

    Need advice on what too look for here! My bike hasn't been ridden much since last summer. I had it stored in a dry garage through the cold months. I installed a new battery a month or so ago, and...
  4. Replies
    11
    Views
    1,348

    Checked the PC III, LIGHTS UP SO ITS OK. Thanks...

    Checked the PC III, LIGHTS UP SO ITS OK. Thanks for the input guys!
  5. Replies
    11
    Views
    1,348

    Bike only has 16-k miles, no didn't change...

    Bike only has 16-k miles, no didn't change gaskets, and didn't torque bolts, but they are tight. I've had this exhaust off 3 or 4 times, so it may be time for new gaskets!
  6. Replies
    11
    Views
    1,348

    I thought so too, so I checked? Guess I'll check...

    I thought so too, so I checked? Guess I'll check again in the morning!
  7. Replies
    11
    Views
    1,348

    Someone please help!

    Ok, here is my problem. I have finally got around to opening my bike up to check the clutch. I did find a dry clutch, as expected. I checked the tube nut, and it was fine. The disc's looked good, the...
  8. Replies
    5
    Views
    1,090

    I bought a kit off ebay, but it was $75.00, and...

    I bought a kit off ebay, but it was $75.00, and though it was ok, it seems expensive based on what I recieved, and the fact that there is no filler plate to block any light in the headlight housing...
  9. Thread: BLUE'S ONLY

    by 1 BAD 9
    Replies
    151
    Views
    36,776

    Sticky: iphone mount on handle bar?

    if so, where did you find it, or did you come up with it yourself?

    LG
  10. Replies
    4
    Views
    793

    So it's open with the engine off!

    So when I forced it, against the spring, I actually closed it? I was hoping that was the case! LOL! So now I just need to cut the wires that I tied it with, and it should go to the open position,...
  11. Replies
    4
    Views
    793

    Not happy with Scorpion tips!

    Just iinstalled the scorpion tips, and I must say I am less than satisfied! I thought they were going to be louder than the JUTAH pipe that I had, but it is quieter? I did tie the exhaust valve in...
  12. Replies
    9
    Views
    1,188

    Remove the butterfly or??

    Did you tie it open or remove it? I have the dummy to put on the actuator, as that's what I installed after I cut the pipe where it goes two into one for the JUTAH mod, and that works fine. I just...
  13. Replies
    9
    Views
    1,188

    Scorpion Tips with or without SET valve?

    I'm installing Scorpion Tips, and don't know if I should disable the SET valve or re-install the actuator so the valve will function. With the JUTAH Mod, I cut the valve out and used the dummy weight...
  14. Replies
    98
    Views
    13,480

    Fast? LOL!

    I matched up against one of those UGLT bikes a few times in time trials at a local 1/8 mile track. I was spankin his butt by a couple lengths, when I noticed he had what I THOUGHT was a turbo charger...
  15. Replies
    4
    Views
    657

    Correct, but....

    I know I would have to remove the CAT and replace it with a piece of pipe, because two tips wont fit on the single pipe in front of the CAT. I just want to know if anyone else has went so far as to...
  16. Replies
    4
    Views
    657

    Scorpion Tips with or without Cat?

    Im going to do the Scorpion Tip mod, but would like to know how everyone else runs it, with or without the cat. converter? I have the Jutah (V-Rod muffler) exhaust now, and I cut the Cat. converter...
  17. Thread: BLUE'S ONLY

    by 1 BAD 9
    Replies
    151
    Views
    36,776

    Sticky: Here is my Burple "1 BAD 9"

    I have a hard time calling it blue!
  18. Replies
    13
    Views
    2,013

    insanely good!

    Not to mention the balance and control!
  19. Replies
    229
    Views
    79,936

    Sticky: Nice thread!

    I cant find my dyno sheet, but I remembner it was 114.5 HP / 109.5 Ft Lbs torque. My best time at a local track, 1/8 mile was 7.569 @ 92.51 MPH. I took first place, (Cruisers only race, no turbo's,...
  20. Replies
    6
    Views
    1,780

    Hollycrap!!!

    It was hard to watch that video! Still cant believe no paint was lost, and not even a mirror was bumped! Lots of "Kaahhoonaas" I say! LOL!
  21. Replies
    17
    Views
    2,458

    Imagine.....

    Someone doing that on a "9"? LOL! That kid can ride!
  22. Thread: Numb Hands

    by 1 BAD 9
    Replies
    37
    Views
    5,926

    So I'm not the only one!

    I have experienced these same symptoms for several years now, but never would have guessed it could be CTS! I'll get that looked at in the near future!

    LG
  23. Replies
    48
    Views
    8,684

    Burple's are the real "Limited Editions!

    It's the only color that was only available for one model year, right? :super:
  24. Replies
    12
    Views
    1,308

    :agree:Done mine like that too!

    :agree:Done mine like that too!
  25. Replies
    2
    Views
    966

    Finally! Nite Shades on my tail light!

    23627

    23628

    Took me long enough, but I am really pleased with the final results! I may at some point wet sand it and the polish it, but it turned out so slick after 4 coats of clear acrylic...
  26. Replies
    0
    Views
    586

    Cruiser only drag race!

    I am talking with a local shop here in North Alabama, (Cycles Unlimited), about scheduling a drag racing event for cruisers only! If things go as expected, this will be a charitable event, at the...
  27. Replies
    82
    Views
    4,520

    I agree! I have beat a few V-rods, and even a...

    I agree! I have beat a few V-rods, and even a Rocket III with a supercharger! I was doing the 1/8 mile against the Rocket, and I beat him 2 out of 4 times! He had reported 225 ft lbs of torque to the...
  28. OUCH!

    Hope you and your 9 are back soon!
  29. Replies
    0
    Views
    461

    Helmets that match a Burple 9?

    Anyone have a good one?
  30. Replies
    18
    Views
    1,318

    1/8 mile is all we have here!

    1/4 mile would suit me better, but we have to take what we can get around here!

    LG
Results 1 to 30 of 97
Page 1 of 4 1 2 3 4