M109 Rider Forums banner

Stealth and knight rider set up

1K views 8 replies 2 participants last post by  Mo H 
#1 ·
Those that are running both, how did you wire them? I know you have to tap in but just wondering anything special I need to do our is there a better way then just cutting wire and twisting them together? I am running the rainy knight rider now and adding the stealth. Thanks

Sent from my LG-D801 using Tapatalk
 
#2 ·
Rainey's night rider is a plug and play into your wire harness and the Raw Design stealth has to be wired into your signals.

 
#4 ·
You can't tie in the knight rider with the stealth. Bro its two wires coming out of the signals and two wires at the signal plug...are you kidding me you can do it...these are the same words that Big B used to push me into what I am today...
 
#6 ·
No you can run both, but separately not together as in wired together.
 
#8 ·
Ok cool, so that is what I'm asking. What is the best way to do that before I start cutting wires.

Sent from my LG-D801 using Tapatalk
The only one you have to wire into your signals is the stealth light. The knight rider is a plug and play.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top