PDA

View Full Version : m90 power ouput?


SilverScreamer
04-26-2009, 03:05 PM
anyone know what the power output is on the M90?, its a great looking bike...looking for the wife.
NC_M90
04-26-2009, 05:06 PM
The power is somewhere around 84 horsepower. Not sure of the torque numbers.
littleup
04-26-2009, 06:47 PM
I had read about 83 and torque maybe 76 or 9 can't remember. Peak torq is about 2600 rpms though. There was a review online that I had read and it had that info.
SiPPMSH
04-28-2009, 01:36 AM
To this day (to my knowledge) no actual horsepower ratings have been released by Suzuki Corp for the 2008 Suzuki M90. However, an independent company dynoed the M90 at 79rwhp @ 5400RPMs. No torque measurements have been listed at this time.
andrewd
04-28-2009, 02:20 AM
im at work, but at home i have the latest issue of an aussie mag where both hp and tq were dyno tested, i'll post up when i get home... but it was much lower than i expected it to be
SiPPMSH
04-28-2009, 03:04 AM
im at work, but at home i have the latest issue of an aussie mag where both hp and tq were dyno tested, i'll post up when i get home... but it was much lower than i expected it to be

Great news andrewd; I look forward to your post. :bigthumbsup:
andrewd
04-28-2009, 09:38 AM
ok according to the April issue of Twowheels (australian mag)

the published figures are 67.3kw@8750rpm and 82nm@4500rpm? wtf??

they do post a tiny tiny image of the dyno graph, which tells a different story though!!!

from what i can make out they dyno printout says that it made in the region of 130nm @ approx 3000rpm and 57kw @ 5000rpm

i really wish they would double check thing before printing!

someone email them for clarification, but i believe the 130nm and almost 60kw to be correct

so approx 81hp and 96lb/ft at the wheel
SiPPMSH
04-28-2009, 09:39 PM
ok according to the April issue of Twowheels (australian mag)

the published figures are 67.3kw@8750rpm and 82nm@4500rpm? wtf??

they do post a tiny tiny image of the dyno graph, which tells a different story though!!!

from what i can make out they dyno printout says that it made in the region of 130nm @ approx 3000rpm and 57kw @ 5000rpm

i really wish they would double check thing before printing!

someone email them for clarification, but i believe the 130nm and almost 60kw to be correct

so approx 81hp and 96lb/ft at the wheel

That's in the ball park of my figures. Great info, thanks.